TipTop Plastic Cement PC-4 350g and Hardener E40 15g

TipTop Plastic Cement PC-4 350g and Hardener E40 15g

Fields of application:
CFC-free, two-component-adhesive for the repair and endless spli-
cing of PVC conveyor belts, for the repair of soft PVC products and for
bonding polyurethane materials.
Application:
Preparing:
• Ambient and material temperature +10 °C up to +45 °C.
• Avoid direct sunlight, avoid the temperature falling below the dew
point (formation of condensation water).
• Bonding surfaces: dry, free from chemicals, grease and oil.
• PVC/polyurethane surfaces: Buff thoroughly, e.g. by means of a
rotary wire brush. Use emery paper to buff thin walled PVC products.
(No bright surface areas!).
• Fabric: Buff the remainders of PVC, until they are even. Buff the
fabric slightly, with care. (Do not damage it!)
• Remove buffing dust without using any fluid.
Mixing:
Thoroughly mix the required quantity of Plastic Cement PC-4 with
hardener E 40 (4% of the total weight of the mixture) by stirring, until
a homogeneous mixture is obtained. Use the mixture within 2 hours
(pot life).
Applying the coats:
Apply 2 even and thin coats onto each bonding surface. (3 coats to
open-meshed, absorbent fabric) AIIow the first coat to dry completely
(at least 1 hour). Let the second coat dry until it is still slightly tacky
(check with the back of your finger). In case of over drying, apply ano-
ther coat.
Bonding:
Put the bonding surfaces on one another, avoiding air inclusions. Sti-
tch on tightly or press on. Let the bonded surface areas (especially
those subjected to high stress) rest at a temperature of +20 °C for at
least 6 hours. Keep them under pressure, if possible.
Caution:
Observe the hazard information and safety advice on the tins or cans!
Note:
The above - mentioned information is the result of field trial. Becau-
se of the differences in materials and operating conditions which are
beyond our control, we recommend in any event that you conduct
adequate tests of your own. No Iiability of any kind can be deduced
from this information.

Qty: 1 tin PC-4 and Hardener E40 15g